- Snaps together for an easy setup.
- Rubber grips keep stairs secure and your pet safe.
- Features 6-inch step height and machine washable carpet tread.
- Great for aging pets, or smaller pets that need the extra help.
- Stairs weigh less than 15 pounds so you can move them to another location easily.
“Snuggle Saturdays” just aren’t the same without your family fur baby in the bed, but the little ones need a boost getting up! The Pet Gear Easy Step III Pet Stair makes going up and down easy on smaller pets or elderly dogs with joint pain. Three wide, deeps steps with a slight incline allow pets to get their whole body on each landing while rubber grips on the bottom keep the stairs securely in place.
| Item Number | 64531 |
|---|---|
| Weight | 9 pounds |
| Dimensions | 25 x 16 x 23 inches |
| Step Rise | 6 inches |
| Step Depth | 9.5 inches |
| Number Of Steps | 3 Steps |
| Placement | Bed & Couch |
| Lifestage | Adult |
| Breed Size | Small Breeds, Medium Breeds, Large Breeds, Giant Breeds |
| Features | Non-slip Tread, Non-skid |
| Material | Plastic |
| Assembly Required | Yes |
| Tools Included | No Tools Required |
| Recommended Pet Weight | up to 150 pounds |
For pets only. Do not leave your pet unattended. Do not use near an open or exposed flame.
⚠️ WARNING: This product can expose you to chemicals including Styrene, which is known to the State of California to cause cancer, and BPA which is known to the State of California to cause birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
To clean carpet treads, remove and machine wash.
- With rubber grippers on the bottom, place right panel part (B) on floor with PET GEAR Logo facing the floor and insert top stair part (E). Keep the STRAIGHT EDGE toward the back and rug facing the top. Make sure there are no gaps between parts after inserted. (If inserting part is difficult put a little dish soap on doweled end before inserting.)
- Insert riser part (C). Make sure there are no gaps between parts after inserting.
- Insert middle stair part (F). Note the CURVED SIDE direction. Make sure there are no gaps between parts after inserting.
- Insert riser part (C). Make sure there are no gaps between parts after inserting.
- Insert bottom stair part (F). Note the CURVED SIDE direction. Make sure there are no gaps between parts after inserting.
- Insert riser part (C). Make sure there are no gaps between parts after inserting.
- Insert dowel part (D). Make sure there are no gaps between parts after inserting.
- Attach left panel part (A). Align all holes before pushing panel down. Make sure there are no gaps between parts after inserting.
















Reviews
There are no reviews yet.